Howto Freifunk Firmware: Unterschied zwischen den Versionen
K |
K |
||
Zeile 6: | Zeile 6: | ||
=== Boot_wait setzen (falls was schiefgeht) === | === Boot_wait setzen (falls was schiefgeht) === | ||
+ | The boot_wait variable needs to be set, to cause the WRT to delay the boot process for a few seconds, allowing a new firmware to be installed through the bootloader. | ||
+ | |||
+ | This variable needs to be set via a "hack" using the ping functionality in the web interface. In the web interface, navigate to the Administration -> Diagnostics page, and hit the Ping button. | ||
+ | |||
+ | Enter each of these lines into the "ip address or domain name" text box, and hit "ping" after each entry: | ||
+ | |||
+ | ;cp${IFS}*/*/nvram${IFS}/tmp/n | ||
+ | ;*/n${IFS}set${IFS}boot_wait=on | ||
+ | ;*/n${IFS}commit | ||
+ | ;*/n${IFS}show>tmp/ping.log | ||
+ | |||
+ | After the last command, a long list of configuration parameters is shown, and it should include | ||
+ | |||
+ | boot_wait=on | ||
+ | |||
+ | aus: http://martybugs.net/wireless/openwrt/flash.cgi | ||
=== Neue Firmware installieren === | === Neue Firmware installieren === |
Version vom 9. März 2005, 19:13 Uhr
Neue Firmware für den Linksys WRT54 G (und GS)
Firmware runterladen
Die Freifunk Firmware findest du unter http://ff-firmware.sourceforge.net/ oder die aktuelle Version 0.6.8 direkt hier. Diese musst Du runterladen und dann ...
Boot_wait setzen (falls was schiefgeht)
The boot_wait variable needs to be set, to cause the WRT to delay the boot process for a few seconds, allowing a new firmware to be installed through the bootloader.
This variable needs to be set via a "hack" using the ping functionality in the web interface. In the web interface, navigate to the Administration -> Diagnostics page, and hit the Ping button.
Enter each of these lines into the "ip address or domain name" text box, and hit "ping" after each entry:
;cp${IFS}*/*/nvram${IFS}/tmp/n ;*/n${IFS}set${IFS}boot_wait=on ;*/n${IFS}commit ;*/n${IFS}show>tmp/ping.log
After the last command, a long list of configuration parameters is shown, and it should include
boot_wait=on
aus: http://martybugs.net/wireless/openwrt/flash.cgi
Neue Firmware installieren
... to be continued
Siehe auch: