HowTo use kamikaze b43: Unterschied zwischen den Versionen
(Konfiguration von TP-Link TL-WR1043ND übernommen) |
K (+test) |
||
| Zeile 50: | Zeile 50: | ||
Danach nur noch bei 'lan' die bridge auskommentieren (mit einem #) und ein 'reboot' - fertig! | Danach nur noch bei 'lan' die bridge auskommentieren (mit einem #) und ein 'reboot' - fertig! | ||
Mutige koennen dann noch mittels 'opkg update ; opkg install olsrd' weiterspielen.... [[Benutzer:Fries43|fries43]] 12:41, 20. Nov. 2009 (UTC) | Mutige koennen dann noch mittels 'opkg update ; opkg install olsrd' weiterspielen.... [[Benutzer:Fries43|fries43]] 12:41, 20. Nov. 2009 (UTC) | ||
| + | |||
| + | =TEST= | ||
| + | <pre> | ||
| + | [12:57:52] … config wifi-device radio0 | ||
| + | option type mac80211 | ||
| + | option channel 5 | ||
| + | option macaddr 94:0c:6d:xx:xx:xx | ||
| + | option hwmode 11ng | ||
| + | option htmode HT20 | ||
| + | list ht_capab HT40+ | ||
| + | list ht_capab HT40- | ||
| + | list ht_capab SHORT-GI-40 | ||
| + | list ht_capab DSSS_CCK-40 | ||
| + | # REMOVE THIS LINE TO ENABLE WIFI: | ||
| + | option disabled 0 | ||
| + | |||
| + | config wifi-iface | ||
| + | option device radio0 | ||
| + | option network lan | ||
| + | option mode ap | ||
| + | option ssid www.evernet-eg.de | ||
| + | option encryption psk2 | ||
| + | option key 12345 | ||
| + | |||
| + | config wifi-iface | ||
| + | option device radio0 | ||
| + | option network freifunk | ||
| + | option mode adhoc | ||
| + | option sw_merge 1 | ||
| + | option ssid sundi.freifunk.net | ||
| + | option encryption 0 | ||
| + | option bssid 02:ca:ff:ee:ba:be | ||
| + | option frag 2346 | ||
| + | </pre> | ||
Version vom 26. August 2010, 11:19 Uhr
Achtung, Technikthema!
Seit den neuesten openwrt.org-Entwicklungen (Nov'2009) laeuft nun auch der Quelloffene b43-WLAN-Treiber mit einem aktuellen Linuxkernel auf den Linksys-Geraeten (oder aehnlicher Hardware):
root@OpenWrt:/# uname -a Linux OpenWrt 2.6.30.9 #1 Fri Nov 13 07:00:26 UTC 2009 mips GNU/Linux
root@OpenWrt:/# iw dev wlan0 station dump
Station 00:1d:73:55:d5:83 (on wlan0)
inactive time: 280 ms
rx bytes: 18070094
rx packets: 65827
tx bytes: 245584
tx packets: 3409
signal: -68 dBm
tx bitrate: 36.0 MBit/s
Garnicht zu erwaehnen brauche ich das der aktuelle OLSR-Dienst und der Rate-Auswahl-Algorithmus "minstrel" problemlos funktioniert. Folgendermassen koennt ihr das selbst nachvollziehen:
Flashen einer aktuellen trunk-Version: http://downloads.openwrt.org/snapshots/trunk/brcm47xx/openwrt-brcm47xx-squashfs.trx
Dann aendern folgender Config Eintraege, um im weimarnetz mitzumischen:
/etc/config/wireless
config wifi-device radio0
option type mac80211
option macaddr <00:AA:BB:CC:DD:EE>
option channel 5
option hwmode 11ng
option htmode HT40+
list ht_capab SHORT-GI-40
list ht_capab DSSS_CCK-40
config wifi-iface
option device radio0
option mode adhoc
option ssid weimarnetz
option bssid 02:ca:ff:ee:ba:be
/etc/config/network (folgenden Eintrag hinzufuegen)
config 'interface' 'weimarnetz'
option 'ifname' 'wlan0'
option 'proto' 'static'
option 'ipaddr' '10.63.15.129' # einstellungen fuer
option 'netmask' '255.0.0.0' # knotennummer 115
option 'dns' '141.1.1.1'
Danach nur noch bei 'lan' die bridge auskommentieren (mit einem #) und ein 'reboot' - fertig!
Mutige koennen dann noch mittels 'opkg update ; opkg install olsrd' weiterspielen.... fries43 12:41, 20. Nov. 2009 (UTC)
TEST
[12:57:52] … config wifi-device radio0
option type mac80211
option channel 5
option macaddr 94:0c:6d:xx:xx:xx
option hwmode 11ng
option htmode HT20
list ht_capab HT40+
list ht_capab HT40-
list ht_capab SHORT-GI-40
list ht_capab DSSS_CCK-40
# REMOVE THIS LINE TO ENABLE WIFI:
option disabled 0
config wifi-iface
option device radio0
option network lan
option mode ap
option ssid www.evernet-eg.de
option encryption psk2
option key 12345
config wifi-iface
option device radio0
option network freifunk
option mode adhoc
option sw_merge 1
option ssid sundi.freifunk.net
option encryption 0
option bssid 02:ca:ff:ee:ba:be
option frag 2346